![](/images/new-backgrounds/1294755/29475553x1.webp)
A n t i - T i p p e r s / W h e e l
L | o | c | k | s |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| E n g l i s h | 27 |
ANTI-TIPPERS/WHEEL LOCKS
WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching hardware is tightened securely – otherwise injury or damage may result.
A. ANTI-TIPPERS
WARNING
The manufacturer strongly recommends ordering the
| A | B | 1 |
|
| ||
|
|
| |
C |
|
|
|
5/32 – 5/16" | E |
| D |
|
|
WARNING
WARNING
Ensure both anti-tippers are adjusted to the same height.
B. WHEEL LOCK ADJUSTMENT (FIGURE 1)
NOTE– Before adjusting or replacing the wheel lock assemblies, ensure that the tires are inflated to the recommended psi on the sidewall of the tire.
1.Ensure the Wheel Lock (A) is in the open (unlocked) position.
2.Loosen the bolt and locknut (B) that secure the wheel lock assembly to the wheel- chair frame (C).
3.Adjust the position of wheel lock until the measurement between the rear wheel (D) and the wheel lock shoe (E) is between 5/32 and 5/16 inches.
4.Securely tighten the bolt and locknut
5.Engage wheel lock and push against the wheelchair and determine if wheel lock engages the wheel lock shoe enough to hold the wheelchair.
6.Repeat the above procedures until the wheel lock holds the wheelchair.
7.Repeat STEPS
8.If 5/32 and
9.Repeat STEPS