Batteries and charging
Procedures for Charging. 24V 10A charger
The 24V 10A charger has one
1Plug into the three pin charging point under the fornt of the control box (Fig. 28).
2Connect the charger to the mains supply by means of the mains plug and switch on.
3At the start of charging the charger will undergo a self test procedure, this is indicated by the indicator flashing, alternating orange/green (Fig. 29).
4When the test is complete and there have been no faults found, charging will commence. This is indicated by a flashing orange only light.
5On return of 90% or the bulk of the charge a steady orange light will be visible.
6When a steady green light is visible the battery is fully charged.
7An automatic switch to a float voltage will occur after a further period of time, and the charger should be left connected to the wheelchair until it is required for use.
8No light indicator will show unless the charging plugs are connected.
9Always switch off at the mains before disconnecting the batteries.
Control box
Charger socket
Fig. 28
Orange/green warning light
Fig. 29
On/Off switch on rear case
27 | Issue 4 |
|
|
