R-4108.A
REASSEMBLING PROCEDURE
REASSEMBLING PROCEDURE
<Reassembling the Slide Holder >
1)Put the axle supporter @ on the slide holder metal @ . Place the spiral spring @ on the metal
@inserting its inner and into the pin hole of the metal @.
2)Insert the outer and of the spiral spring @ through the pin hole of the washer @.
CA)( 8)
Fig. 7
3)Keeping the spiral spring, the inner end in the pin hoie, tum the washer @ in the arrow direction
(A)and to be positioned as shown by (B) in Fig. 7.
Then, place the slide glass retainer @ over the washer @ inserting the spiral spring outer end into the pin hole of the retainer @ and fasten the screw @. (Fig. 8)
Fig. 8
4)Fix the above slide glass retainer assembly on the holder @. The latter is to be attached to the stage.
- 8 -
