R-4106.A
REASSEMBL Y PROCEDURE | 3. UW·tube |
|
|
3.UW-tube
1)Applying a trifle of adhesive No. 616
to the threaded part ofmount @,
screw it into bottom plate @ (Fig. 25).
2)Attach sliding plate
@ and dovetail groove @ (the
one that has not
been disassembled) to @, transitorily.
3)Perform the posi- tioning of @ in respective to @
as below:
lnsert the male dove· | Fig. 25 |
|
tail of prism holder @ into the fiducial |
|
|
one (has not been disassembled) of @, | "~ | ,~. |
and move @ parallel in the direction of | 'CI | |
'..::::'./, 8 | 1 17 1 | |
|
| |
the arrow, as shown in Fig. 26. ln this |
|
|
case, keep thê slack within about O.Olmm. |
|
|
4)Apply oil G7920 to the sliding surface
for dovetail fitting. Check for smooth sliding, and for slow dropping of @ by
itself, when holding @ with the hand. |
|
5) Apply adhesive No. 350 into @xa. | Fig. 26 |
- 30-
