R-4104.A

ADJUSTMENT

1. Torque of Coane Focus Knob

2. Smooth

of the Left Fine Focus Knob

ADJUSTMENT

1.Torque of Coarse Focus Knob

1)Referring to Reassembly Procedure (P. 32), insert wave washer e@ and adjusting washer e@ in sequence, as shown in Fig. 42, into coarse focus shaft (@.

After screwing coarse focus knob @ and bush

@into @, make adjustment of the torque to

400g - SOOg, by means of washers @ , @ .

iº.

01121

2) When a correct torque is obtained, disassemble coarse

Fig. 42

 

focus knob and bush e@.

Applying adhesive No. 410 to the thread, tlx @ and @ in position. Be careful not to let the adhesive enter the internal surface of @ .

(

2.Smooth Turning of the Laft Fine Focus Knob

1)Referring to Reassembly Procedure (P. 32), attach G7920 onto both sides of washer @, and insert the washer into fine focus shaft e@. Then, insert left fme focus knob @ into e@ (beforehand, place set screw ~ into

@), and set it with @ in such a position

__,

that the thrust slack of the knob is not felt by touching with the fmger.

li

2)Make sure of seizurc between coarse focus knobs C@1) and @ , and their smooth tuming.

Fig. 43

- 38 -

Page 41
Image 41
Nikon 50i and E100 manual Torque of Coarse Focus Knob, Smooth Turning of the Laft Fine Focus Knob, Adjustment