Sunrise Medical P-222 Drive Wheel, Manual Wheelchair Conversion KIT Joystick, Dynamic Stabilizer

34	I X . S e t - U p , A d j u s t m e n t & U s e
2.	Back Angle Adjustment on Seat Frame
	a. Remove the front securing bolt (C) on the side of
	the backrest hinge plate.
	b. Loosen the lower rear bolt (D)
	c. Set at desired angle. There are five holes (in 4º	D
	increments) to choose from.	C
	d. Reinstall the front bolt and tighten both bolts
	securely.
L. 12" DRIVE WHEEL
Drive Wheel Position Adjustment

I X . S e t - U p , A d j u s t m e n t & U s e	35
MANUAL WHEELCHAIR CONVERSION KIT
A. JOYSTICK
Removal
a. Disconnect the joystick by pulling back on the
retaining collar (A).
b. Remove joystick power cable from armrest.
c. Remove joystick assembly.	A
B. POWER DRIVE UNIT

Detachment

a. Remove the seat and main frame and the batteries. b. Remove the four (4) bolts (B) using a 1/2"

wrench from each quick-connect socket.

c. Move the socket forward or backwards to the desired position.

d. Reinstall the four (4) bolts in the quick-connect socket. Use a torque setting of 240 in.-lbs. (27 N.m) to tighten bolts.

M. DYNAMIC STABILIZER

B

a. Release both quick-connect levers (B) until completely disengaged.

b. Lift seat and main frame off of power unit. c. Set power unit aside.

C. WHEEL LOCKS

Wheel locks are installed by Sunrise when requested on the Quickie P-222.

Adjustment

B

4" Rear Wheel Adjustment
a. Remove rear batteries.
b. Remove the upper pivot bolt (C)
on the rear wheel spring.
c. Set at desired height.	C
d. Tighten nut. Use a torque setting of 240 in.-lbs.
(27 N.m) to tighten nut.
e. Height adjustment may also be made by using extra
set of mounting holes on rear wheel mount bracket.
NOTE– The lowest point of the rear wheels should be 1/4" to
1/2" (6 to 13 mm) from the ground to allow for proper
clearance (with the tires properly inflated and rider
sitting in the chair). A smaller clearance produces less
rocking motion, and a larger clearance allows easier
movement on deep carpets.

NOTE– In addition to the user’s weight, the seat depth and back angle adjustment will effect this choice. Choose the position that provides the most comfortable transi- tion onto and off of the dynamic stabilizer wheels.

The wheel locks mount on a split clamp system. Use a torque of 100 in./lbs. (11.3Nm) when adjusting the position of the wheel locks.

1.Loosen the screws on the side of each clamp (C) using a 3/16" allen wrench. Do not attempt to remove one screw at a time.

2.Slide assembly toward rear wheel until clamp embeds into tire to prevent wheel movement when in the locked position.

3.Adjust angle position. Tighten screws.

C

930466 Rev. A 930466 Rev. A