Sunrise Medical P-222 instruction manual Folding Backrest, Elevating Legrest Optional

30 I X . S e t - U p , A d j u s t m e n t & U s e

C. FOLDING BACKREST

Quickie P-222 wheelchairs are shipped with backrest in folded position.

1.Upright Positioning

a.Lift backrest to upright position so that latch handles (A) lock into place.

b.Backrest is ready for use.

2. Folding Backrest A

a. Lift and turn backrest latch handles (A) inward or outward.

b. Fold backrest forward.

I X . S e t - U p , A d j u s t m e n t & U s e		31
E	ELEVATING LEGREST (OPTIONAL)
1.	Installation
To install or remove Elevating Legrest (ELR) see instruc-
tions for Swing-away Footrest installation page 28.
2.	Adjustment
	a. To raise legrest, lift to desired position. Legrest	G
	will automatically lock in place.
	b. To lower legrest, while seated in chair, first lift
	slightly then press release lever (G) down and
	lower legrest to desired position.

F. REMOTE JOYSTICK INSTALLATION

CAUTION: Backrest latches must be locked into place before operating wheelchair.

D. SWING-AWAY FOOTRESTS

1.Installation

a.Place swing-away pivot pin (B) into the locating hole (C) on top of the hanger mount with the footrest facing outward from frame.

b.Rotate the footrest inward until latch plate locks

(D)into place on locking bolt.

2.Removal

a.To remove footrest, press quick-release lever (E).

b.Rotate footrest outward and lift.

3.Height Adjustment

a.Loosen all four (4) set screws (F) in the hanger frame tube.

b.Reposition footrest height.

c.Re-tighten all set screws (F).

B

C

D

E

F F

1.To Connect

a.Line up small cylindrical connector with its receptacle on the rear of the joystick.

b.Push in firmly.

2.To disconnect

Pull back on the retaining ring (H) of the cylindrical connector until it disconnects from the joystick box.

G.TO ADJUST THE HEIGHT OF THE REMOTE JOYSTICK

a.Remove the two pan-head screws (A), securing the angle bracket mount (B).

b.Remove the Joystick from the mount by unfas- tening the two screws (C) on the underside of the mount.

c.Position angle bracket mount such that you achieve the desired joystick height. Four posi- tions are available by relocating the mount either on the top or bottom of the mounting bar

(D)and/or by rotation of the angle bracket mount.

B	A
C
	D

930466 Rev. A 930466 Rev. A