![](/images/new-backgrounds/1137780/13778029x1.webp)
I X . S E T U P & A D J U S T M E N T
I X . S E T U P & A D J U S T M E N T
C. ARTICULATING LEGREST (Optional)
1.Installation
To install or remove Articulating Legrest (ALR) see instructions for
2.Adjustment
a.To raise legrest, lift to desired position. Legrest will automatically lock in place.
b.To lower, while seated in chair, press release lever (a) forward and lower legrest to desired position. Legrest will automatically lock in place.
D. ELEVATING LEGREST (Optional)
1. | Installation |
| To install or remove Elevating Legrest |
| (ELR) see instructions for |
| Footrests installation. |
2. | Adjustment |
| a. To raise legrest, lift to desired position. |
| Legrest will automatically lock in place. |
| b. To lower, while seated in chair, press |
| release lever (b) forward and lower |
a
b
F.DUAL-POST, HEIGHT- ADJUSTABLE ARMRESTS
1.Installation or Removal
a.The assembly is held securely in place when the lever (a) is facing forward.
b.Pull back on securing lever.
c.Insert or remove armrest.
d.Return securing lever to locked position.
2.Height-Adjustment
a.Release the upper securing lever (a).
b.Set at desired height.
c.Return securing lever to locked position.
d.Move armrest up or down to allow armrest to snap into place.
G.ADJUSTABLE LOCKING FLIP- UP ARMRESTS (Optional)
1.Adjustment
a.Loosen clamp bolts (a) and (b).
b.Move clamp and bushing up or down backrest posts to desired position.
c.Tighten bolts.
d.Repeat the process for the other armrest.
a
b
a
legrest to desired position. Legrest |
will automatically lock in place. |
E. CASTERS
1.Installation
a.Remove dust cover (a) from caster housing. Pry dust cover off using a back and forth motion.
b.Caster assembly holds one nut (b) and one washer (c). Remove nut and washer.
c.Insert caster stem (d) into caster housing (e) and place washer on stem.
d.Replace nut on caster stem and tighten until all play is removed; then loosen approximately 1/8 turn, yet still allow- ing for free rotation.
e.Replace dust cover to caster housing.
a b
c
d
e
2.Angle-Adjustment
a.Loosen bolt (b).
b.Set armrest at desired angle using pre- set holes in armrest angle plate.
c.Tighten bolt.
930356 Rev. B | 28 | 29 | 930356 Rev. B |