![](/images/new-backgrounds/1137780/13778033x1.webp)
I X . S E T U P & A D J U S T M E N T
K. FIXED/ADJUSTABLE BACKREST
The backrest comes with an
1. | b | a |
|
|
a. Loosen and remove bolt (a)
b. Set backrest at desired angle using pre- set holes in armrest angle plate.
c.Replace and tighten bolt.
d.Repeat on other side.
Important Note: The adjustment on each side of the chair should be exactly equal.
2.Depth Adjustment
a.Loosen bolts (b) from front and rear linkages.
b.Remove bolt.
c.Reposition linkages on seat frame.
d.Replace bolts and tighten.
L. STROLLER HANDLES (Optional)
a
1. Installation |
|
a. Press button (a) on the stroller handle | b |
so that release pins are drawn inside |
|
the tube. |
|
b. Insert the tube into the back tube |
|
receiver (b) and the release pin is |
|
through the receiver mounting hole. |
|
I X . S E T U P & A D J U S T M E N T
M. WHEEL LOCKS
Quickie T45 wheelchairs are standard with wheel locks. Wheel locks are installed by Sunrise unless you have requested otherwise.
Note: Use a torque setting of 100 in./lbs when
1.Adjustment
a.Loosen the screws on the side of each clamp. Do not attempt to remove one screw at a time.
b.Slide assembly toward rear wheel until clamp embeds into tire to prevent wheel movement, when in locked position.
c.Adjust angle to position.
d.Tighten screws.
N. CHECK-OUT
After the wheelchair is assembled and adjusted, it should roll smoothly and easily. All accessories should also perform smoothly.
If you have any problems, follow these procedures.
1.Review the
2.Review troubleshooting guide.
3.If your problem persists, contact your authorized supplier. If you still have a problem after contacting your autho- rized supplier, contact Sunrise cus- tomer service. See the introduction page for details on how to contact your authorized supplier or Sunrise customer service.
930356 Rev. B | 32 | 33 | 930356 Rev. B |