Sunrise Medical Z-500 Elevating Legrest Optional, Remote Joystick Installation, Wheel Locks

30	I X . S e t - U p , A d j u s t m e n t & U s e
D. ELEVATING LEGREST (OPTIONAL)
1.	Installation	B
	To install or remove Elevating Legrest (ELR) see
	instructions for Swing-away Footrest installation
	on page 28.
2.	Adjustment
	a. To raise legrest, lift to desired position. Legrest
	will automatically lock in place.
	b. To lower legrest, while seated in chair, lift
	legrest slightly while pressing release lever (B)	Elevating Legrests
	down and lower legrest to desired position.
	Legrest will automatically lock in place.	B
E. REMOTE JOYSTICK INSTALLATION

I X . S e t - U p , A d j u s t m e n t & U s e	31
G. REMOTE JOYSTICK SWING-AWAY RETRACTABLE
MOUNT (OPTIONAL)
The remote joystick is mounted with a mechanism
which allows the control to be locked in a forward or
retracted position using magnets.
Adjustment
a. To retract joystick, push outward on the inside of
joystick.
b. Push joystick away from front of armrest until it
locks into retracted position.
c. To return to forward position, push joystick
forward until it locks into place.

1. To Connect

a. Line up small cylindrical connector with its receptacle on the rear of the joystick.

b. Push in firmly.

2. To disconnect

Pull back on the retaining ring (H) of the cylindrical
connector until it disconnects from the joystick box.	90º Elevating Legrests

H. SOLID BACK AND SEAT INSERT

1. Installation

a. Place the solid back hook clamps (A) on the

push handles.

b. Position solid seat on the top of front frame and

press down until the saddles (B) are secured on

the frame.

c. Insert the quick-release pins (C) through the

mounting hole on the hook clamps.

C

A

B

F.TO ADJUST THE HEIGHT OF THE REMOTE JOYSTICK

a.Remove the two pan-head screws (A), securing the angle bracket mount (B).

b.Remove the Joystick from the mount by unfas- tening the two screws (C) on the underside of the mount.

c.Position angle bracket mount such that you achieve the desired joystick height. Four posi- tions are available by relocating the mount either on the top or bottom of the mounting bar

(D)and/or by rotation of the angle bracket mount.

H

Remote Joystick

B	A
C
	D

I. WHEEL LOCKS

Quickie wheelchairs are shipped with high-mount wheel
locks. Wheel locks are installed at Sunrise unless you
have requested otherwise.
Use a torque setting of 100 in./lbs when setting-up
wheel locks.
1. High-Mount Wheel Lock:
a. Loosen the screws on the top of each clamp. Do
not attempt to remove one screw at a time.
b. Slide assembly toward rear wheel until clamp (D)
embeds into tire to prevent wheel movement
when in locked position.
c. Adjust angle position.
d. Tighten screws.	D

930578 Rev. B 930578 Rev. B