Sunrise Medical Z-500 Check-Out, Footboard, SWING-AWAY Footrests, Articulating Legrest Optional

28 I X . S e t - U p , A d j u s t m e n t & U s e

CHECK-OUT

Be sure this chair performs to your chosen operational settings. If it does not, turn the chair off immediately and reprogram with the Quickie QTRONIX Programmer.

If you do not own a Quickie QTRONIX Programmer have your supplier reprogram your wheelchair as needed. Or, you can order a Quickie QTRONIX Programmer for your own use, from your supplier.

NOTE– Repeat this procedure until the chair performs to your specifications

I X . S e t - U p , A d j u s t m e n t & U s e		29
B. 90° FOOTBOARD
1.	Height-Adjustment
	a. Loosen the four clamp bolts (A) underneath the
	footboard assembly.
	b. Position footplate at desired height.
	c. The adjustment on each side of the footrest	A
	should be of equal height.
	d. Tighten nuts.
2.	Angle-Adjustment
	a. Loosen the four nuts (B) underneath the footboard
	assembly until the mounting tubes rotate freely.
	b. Adjust mounting tube length, by sliding the
	tubes inward or outward so it slides easily into

When properly set-up, this chair will operate smoothly. Check to see that all components work properly. If you detect a problem, be sure to correct it before use.

A. SWING-AWAY FOOTRESTS

1.Installation

a.Place swing-away pivot saddle (A) into the receiver (B) on front frame tube with the footrest facing outward from the frame.

b.Rotate the footrest inward until it locks into place on locking bolt.

2.Removal

a.To remove footrest, push release latch (C) toward the frame.

b.Rotate footrest outward, and lift.

3.Height-Adjustment

a.Loosen set screws (D).

b.Slide footrest extension up or down inside frame tube to desired height.

c.Tighten set screws.

4.Footplate Angle-Adjustment

a.Loosen the retaining bolt (E) in the frame tube.

b.Reposition footplate to desired angle.

c.Tighten bolt.

A

B

C

D

the sleeves.
c. Adjust the angle of the footboard.
d. Slide it forward or backward for
correct placement.	B
e. Tighten nuts.
C. ARTICULATING LEGREST (OPTIONAL)
1. Installation	A
To install or remove Articulating Legrest (ALR)
see instructions for Swing-away Footrest installa-
tion on page 28.

2. Adjustment

a. To raise legrest, lift to desired position.
Legrest will automatically lock in place.
b. To lower legrest, while seated in chair, first lift
slightly then lift release lever (A) up and lower
legrest to desired position. Legrest will automat-	Articulating Legrests
ically lock in place.

E

930578 Rev. B 930578 Rev. B