C-2
SUPERSERVER 5014C-T User's Manual
Configuring BIOS Settings (Native Mode)
1. Press the <Del> key during system bootup to enter the BIOS Setup Utility.
Note: for the first time powering on the system, we recommend you load
the Optimized Default Settings. If you have already done so, please skip to
Step 3.
2. Use the arrow keys to select the "Exit" Settings. Once in the "Exit"
settings, scroll down to select "Load Optimized Default Settings" and press
the <Enter> key. Select "OK" to confirm the selection. Press the <Enter>
key to load the default settings for the BIOS.
3. Use the arrow keys to select the "Advanced" BIOS heading.
4. Scroll down to "Advanced Chipset Control" and press the <Enter> key to
select.
5. Select "On-Chip Serial ATA", and press the <Enter> key. When the sub-
menu appears, "Enhanced Mode".
6. Scroll up to "SATA Mode" and press the <Enter> key to select. When the
sub-menu appears, select "RAID".
7. Tap "Esc" and scroll down to "Exit". Select "Save and Exit" from the
"Exit" menu, then press <Enter> to save the changes and exit the BIOS.
8. Once you've exited the BIOS Utility, the system will re-boot.
ATA Operating Modes
You can select from the following two modes: Legacy mode and Native mode.
SATA Operating Modes
You can select from the following modes: Auto, Combined, Enhanced and
SATA Only Mode. The number of devices supported by these modes are listed
below:
SATA Only: a maximum of 4 devices are supported (4 SATA)
Auto Mode: a maximum of 6 devices supported (4 SATA + 2 IDE)
Enhanced Mode: a maximum of 6 devices supported (4 SATA + 2 IDE)
Combined Mode: a maximum of 4 devices supported (2 SATA + 2 IDE)