SUPER MICRO Computer H8QI6-F, H8QII-F user manual Power On LED, NMI Button, LAN1/2 Ethernet Ports

Chapter 2: Installation

NIC2 (LAN2) LED

The LED connections for LAN2 are on pins 9 and 10 of JF1. Attach LAN LED cables to display network activity. See the table on the right for pin definitions.

NIC1 (LAN1) LED

The LED connections for LAN1 are on pins 11 and 12 of JF1. Attach LAN LED cables to display network activity. See the table on the right for pin definitions.

HDD LED

The HDD LED connection is located on pins 13 and 14 of JF1. Attach the hard drive LED cable here to display disk activity (for any hard drives on the system, including SAS, Serial ATA and IDE). See the table on the right for pin definitions

Power On LED

The Power On LED connector is located on pins 15 and 16 of JF1. This connection is used to provide LED indication of power being supplied to the system. See the table on the right for pin definitions.

NMI Button

The non-maskable interrupt button header is located on pins 19 and 20 of JF1. Refer to the table on the right for pin definitions.

LAN1/2 (Ethernet Ports)

Two Gigabit Ethernet ports (designated LAN1 and LAN2) are located beside the VGA port. Additionally, there is a dedicated LAN poor for IPMI beside the two rear USB ports. These Ethernet ports accept RJ45 type cables.

NIC2 LED

Pin Definitions

(JF1)

Pin# Definition

9Vcc

10Ground

NIC1 LED

Pin Definitions

(JF1)

Pin# Definition

11Vcc

12Ground

HDD LED

Pin Definitions

(JF1)

Pin# Definition

13Vcc

14HD Active

Power LED

Pin Definitions

(JF1)

Pin# Definition

155V Stby

16Control

NMI Button

Pin Definitions

(JF1)

Pin# Definition

19Control

20Ground

2-9