SUPER MICRO Computer X7SLA-H, X7SLA-L Installing DDR2 Memory, Dimm Installation, Memory Support

X7SLA-L/X7SLA-H User's Manual

2-4 Installing DDR2 Memory

Note: Check the Supermicro web site for recommended memory modules.

CAUTION

Exercise extreme care when installing or removing

DIMM modules to prevent any possible damage.

DIMM Installation

1.Insert the desired number of DIMMs into the memory slots, starting with DIMM1A. Insert each DIMM module vertically into its slot. Pay attention to the notch along the bottom of the module to prevent incorrect DIMM module installation.

2.Gently press down on the DIMM module until it snaps into place in the slot. Repeat step 1 to install DIMM1B if needed.

Memory Support

The X7SLA-L/X7SLA-H supports up to 2GB Unbuffered Non-ECC DDR2 533/400 in 2 DIMM slots. Populating these DIMM modules with a pair of memory modules of the same type and same size will result in interleaved memory, which will im- prove memory performance.

Installing and Removing DIMMs

KB/MOUSE

USB0/1

COM1

VGA

JPW1

DIMM1B

DIMM1A

Memory

Bank

LAN1

LAN2

DESIGNED IN USA

945GC

CPU

Tested to Comply With FCC Standards FOR HOME OR OFFICE USE

JPL1-2:LAN1/2 1-2:ENABLE 2-3:DISABLE

SLOT7 PCI-E X4 in X8

JF1 1

IDE

H-X7SLA

ICH7R		I-SATA2	I-SATA3
SLOT6 PCI-E X8
		I-SATA0	I-SATA1
COM2		JL1:CHASSIS	INTRUSION
SLOT5 PCI 33MHZ
JPW2 for Device Power Only
USB4/5	USB7	USB6
USB2/3

2-4