Do not attempt to repaint the appliance until the finish is completely cured (see
Front Glass Enclosure Panel, Removal and Installation
WARNING
Do not operate appliance with the glass front removed, cracked or broken. Replacement of the glass should be done by a licensed or qualified service technician.
WARNING
Do not attempt to substitute the materials used on this door, or replace cracked or broken glass with any materials other than those provided by the appliance manufacturer.
WARNING
Handle this glass with extreme care! Tempered glass is suscep- tible to damage – do not scratch or handle roughly while rein- stalling the glass door frame.
WARNING
Do not attempt to touch the front enclosure glass with your hands while the fireplace is in use.
WARNING
The glass door of this appli- ance must only be replaced as a complete unit as provided by the manufacturer. Do not attempt to replace broken, cracked or chipped glass separately.
These are
Note: The flame appearance will be dimin- ished while the front glass enclosure panel is removed.
During this appliance checkout and adjust- ment period, a potential safety hazard exists
-EXERCISE EXTREME CAUTION to prevent the occurrence of any burn injuries from the exposed flames or hot surfaces. Also note, that while the front glass enclosure panel (or any of the panels) is removed, the flame appearance will appear to be smaller than normal.
| Top Flange on |
| Glass Door |
| Glass Door |
Bottom |
|
Glass Door | Firebox Floor |
| Glass Door Latch |
Figure 6 - INSTALLING GLASS DOOR |
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
Removing Glass Enclosure Panels
(see Figure 6)
1.Remove the top louver assembly by lifting it up and pulling it out.
2.Remove the control compartment access door (see removal instructions on Page 3 - Removing Control Compartment Door).
3.Locate the two (2) latches at the top of the control compartment. To disengage the two latches from the bottom
4.Swing the bottom of the door out and raise it slightly to lift the top flange of the door frame away from the appliance.
Installing Glass Enclosure Panels
(see Figure 6)
1.Visually inspect the gasket on the backside of the glass panel. The gasket surface must be clean, free of irregularities and seated firmly.
2.Position the glass enclosure panel in front of the firebox opening at a 45 degree angle and engage the top flange over the lip at the top of the firebox opening. See Figure 6.
3.Swing the glass enclosure panel down and back. Ensure the gasket seats evenly as the panel draws shut. Engage the
4.Reinstall top louver assembly and control compartment door see installation instruc- tions on Page 3, Reinstalling Control Compartment Door).