INSTALL Logs, VOLCANIC STONE and
GLOWING EMBERS
Carefully position the ceramic fiber logs and twigs over the burner according to the following steps, while referring to Figure 7.
1.Set the rear log on the raised log support brackets at the rear of the firebox, fitting the slots in the logs over the brackets.
2.Position the front log with the pins for the two side twigs in the up position, and the two vertical burner tabs recessed into the two notches at the rear of the log. Check for recessing of brackets into log notches (by touch) to verify correct log placement.
3.Insert the alignment hole of the left twig over the front log's left pin. Rotate the left twig until it just touches the edge of the ember bracket.
4.Insert the alignment hole of the right twig over the front log's right pin. Rotate the right twig until it almost touches the front panel glass.
Note: Proper twig placement is critical in the gaps between the flame peaks and should be positioned so that at no time they impinge the flames.
Glowing Ember/Volcanic Stone Placement
Remove the replacement rockwool (Glowing Embers) from the packaging and tear into quarter size pieces (see Figure 8 ).
Spread rockwool
When properly positioned, the rockwool will unevenly cover approximately 85% of the burner screen, with no appreciable gaps or openings.
To install Decorative Volcanic Stone, mound up a portion of the volcanic stone in front of the burner in a pattern to suite individual taste.
WARNING
Logs get very hot and will remain hot up to one hour after gas supply is turned off. Handle only when logs are cool. Turn off all electricity to the appli- ance before you install grate and logs.
WARNING
DO NOT attemptto install the logs until the appliance installation has been completed, the gas line connected and tested for leaks and the initial burner operation has been checked out.
WARNING
The size and position of the log set was engineered to give the appli- ance a safe, reliable and attrac- tive flame pattern. Any attempt to use a different log set in the fireplace will void the warranty and will result in incomplete combustion, sooting, and poor flame quality.
WARNING
This appliance is not designed to burn wood. Any attempt to do so could cause irreparable damage to appliance and prove hazardous to your safety.
Separate into Quarter
Size (separate) Pieces
Bag of Glowing
Embers (rockwool)
Figure 8 - Glowing Embers
REFERENCE
Firebox Accessories / Parts
Cat. No. | Model No. | Description | |
|
|
| |
88L53 | FGE | Bag of Glowing Embers | |
|
| (1 oz. rockwool) | |
|
|
| |
80L42 | FDVS | Bag of Decorative | |
Volcanic Stone | |||
|
| ||
|
|
|
Table 8
Figure 7 - Log Set (Shown With Optional Log Rack)
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
