Panasonic PV-GS250 Install a button-type battery, Remote control usable range

Before using

(14)Recording start/stop button [START/ STOP] ¢

(15)Playback button [1]

(16)Fast forward/cue button [5]

(17)Enter button [ENTER] -22-

¢means that these buttons function in the same manner as the corresponding buttons on the Camcorder.

ªInstall a button-type battery

Install the button-type battery supplied in the remote control before using it.

1While pressing the stopper 1, pull out the battery holder.

1

2Set the button-type battery with its (i) mark facing upward and slide the battery holder back into place.

Warning

Danger of explosion if battery is incorrectly replaced.

Replace only with the same or equivalent type recommended by the equipment manufacturer. Discard used batteries according to manufacturer’s instructions. Risk of fire, explosion and burns. Do not recharge, disassemble, heat above 212°F (100°C) or incinerate. Keep the Button- Type battery out of the reach of children. Never put Button-Type battery in mouth. If swallowed, call your doctor.

Replace battery with Panasonic PART NO. CR2025 only. Use of another battery may present a risk of fire or explosion.

Caution: Battery may explode if mistreated. Dispose of used battery promptly. Keep away from children.

Do not recharge, disassemble or dispose of in fire.

ªRemote control usable range

≥The distance between the remote control and the Camcorder: Within approx. 15 feet (5 m) Angle: Approx. 10o up and 15o down, left, and right

ªSelecting the remote control mode

If 2 Camcorders are used simultaneously, set the mode for one pair of Camcorder and remote control to [VCR1] and that of the other pair to [VCR2]. This will prevent interference between the 2 pairs. (The default setting is [VCR1]. When the button-type battery is replaced, the setting will revert to the default [VCR1].)

1Setting on the Camcorder:

Set [SETUP] >> [REMOTE] >> [VCR1] or [VCR2].

2Setting on the remote control:

STILL ADV PAUSE STILL ADV VOL

2	1
	STOP

VAR

[VCR1]:

Press [D] and [∫] simultaneously. 1 [VCR2]:

Press [E] and [∫] simultaneously. 2

ªConcerning the button-type battery

≥When the button-type battery runs down, replace it with a new battery (part number: CR2025). The battery is normally expected to last about 1 year, but it depends on operation frequency.

≥Keep the button-type battery out of the reach of children.

≥If the remote control mode of the Camcorder and that of the remote control do not match with each other, “REMOTE” will appear. When the remote control is operated for the first time after the Camcorder is turned on, “CHECK REMOTE MODE” (-67-) will appear and operation is impossible. Set the same remote control mode.

≥The remote control is intended for indoor operation. Outdoors or under strong light, the Camcorder may not operate properly even within the usable ranges.

≥Within a 3 feet (1 m) range, you can operate the remote control using the remote control sensor on the LCD monitor side of the Camcorder.

25

LSQT0862