Contents
and PB12-ISD/VPowered Box
Contents
Pages 4- 7 Setup, integration, and calibration
Page 7- 8 Powered box amp features
SV Subwoofers
Welcome
Ron Stimpson Co-FounderSVS
SV Subwoofers
About your SVS Subwoofer
Page
SV Subwoofers
Setup, calibrating and integration
DD/DTS Processor/Receiver
Subwoofer “Out”
SV Subwoofers
More Setup, calibrating and integration
“Y” cable/splitter from receiver
DD/DTS Processor/Receiver
SV Subwoofers
Is your receiver connected to the sub amp? Use a shielded RCA cable sometimes called a “patch cord” to connect the subwoofer output of your DD/DTS receiver to either input jack of your SVS’s dedicated amp. Again, you’ll need to “split” the bass signal with a “Y Cable” if you have a pair of subs. You only need feed one of the two inputs either Right or Left of any Powered Box SVS however
Page
Page
SV Subwoofers
But what’s “too high”?? Tastes vary, and so do movie soundtracks, but your SVS is capable of tremendous levels of low distortion, low frequency bass - far more than most subs. Take advantage of this, especially if you like action movies with lots of “.1” channel LFE action, and give the sub a bit more “bump” during calibration also known as running the sub “hot”. Keep in mind too that the human ear is relatively in- sensitive to low frequencies. This, coupled with the fact most folks don’t watch movies at Dolby Digital theater reference level loud!, means turning the bass up a few decibels usually yields a better movie sound experience
SV Subwoofers
ion is the difficult job of the phase control. Essentially, “phase” varies the timing of the bass waves coming from the sub. But don’t despair if you don’t hear much differ- ence with changes to the phase knob - the effect of bass cancellation will vary by volume and frequency in your room, and no single setting is likely to ever be “perfect”. One simple technique to optimize phase is to find a nice “bassy” loop such as the menu of the “Godzilla” DVD and measure SPL response at various bass peaks. As the loop runs, you can have an assistant adjust the phase control. When you see the most response on a given bass passage, typically that’s the setting with the least room-inducedcancellation for the frequencies of the demo loop
Page
80Figure
SV Subwoofers
Page
SVS PEQ Controls
SV Subwoofers
Page
50Hz - 37.5Hz= 0.33 37.5Hz
SV Subwoofers
Page
SV Subwoofers
Subsonic Filter and Port Tuning
Stock tune no ports blocked
20Hz
Page
SV Subwoofers
Bassy demo scenes to die for
SV Subwoofers
More Bassy demo scenes
SV Subwoofers
Warranty