CV301-8CH 82
SVAT ELECTRONICS
now you can see
Cannot power o DVR • The DVR is set to run as long as it is plugged in. To power o the DVR
disconnect the power cable
Playback video is choppy • Check the FPS for each camera that is recording the choppy video.
Refer to your settings in the main menu. The more FPS the smoother
the video. If the FPS is set too low the video will appear choppy
The schedule is not recording
properly to my set times
• Check to see if you have the proper time set on your DVR. Refer to the
instruction manual under System → Date and Time (Pg. 35)
• Double check your schedule record times – you may have it set on the
no record function
• Remember that the DVR works on a 24 hour clock. 13:00 would be 1
O’clock PM
There is a beeping noise
whenever motion is detected
• Buzzer is set to on, go to the alarm set up and turn the buzzer
function o
I cannot see (all/one) of the
camera(s) on the monitor
• Check if the cameras are properly hooked up to the back of the DVR
and to a power source
• If using the 4 to 1 power connector, make sure it is plugged into a
power source and each of the cameras
• Check Camera Setup from the main menu to see if any of the cameras
are turned o
I have lost video footage • This could be from lost footage due to tampering of cameras. Make
sure to check all connections are secure and set properly
• This could be because HDD overwrite is enabled. This means that once
the HDD is full the DVR will begin overwriting the earliest
stored footage
• Try unplugging the power to the cameras and/or DVR and plugging it
back in
The hard drive is lling up too
quickly
• Check the video quality you are using. If you are using a high video
quality then the hard drive will ll up faster. Trying lowering the
video quality
• Adjust your schedule or resolution – If you are on Normal Record for 24
hours a day the hard drive will ll up faster. Try switching some times
to alarm record
I am prompted to put in a
password for everything
• This is because you have the password enable set to ON in the
system menu
My DVR is connected to my
router, and both devices have
DHCP enabled, but my DVR will
not acquire an IP address
• Check Ethernet connections, ensure that the connection lights are on
(on router and back of DVR)
• Try using a dierent Ethernet cable and/or a dierent port on your
router
DVR TROUBLESHOOTING