PREPARATION FOR USE
ANTENNA/CABLE CONNECTION
Cables used here are commercially available.
[ANTENNA CONNECTION] | [CATV/SATELLITE CONNECTION] |
VHF/UHF
VHF
UHF
VHF
or
UHF
OR
VHF/UHF Combiner
| OR |
Flat twin- | Adaptor |
lead cable |
|
CATV Box or
Satellite Box *
| OUT | IN |
ANT. | COAXIAL | From Cable System or |
| AUDIO OUT |
|
|
| Satellite Antenna |
| ANT. | |
| OR | Coaxial Cable |
From Cable System
[Fig. 4]
*Some cable TV systems use scrambled signals and require a special converter to receive these channels. Consult your local cable company.
Note to CATV system installer:
This reminder is provided to call the CATV system installer’s attention to Article
NOTE: | Bent pin |
|
• Before plugging the antenna into the ANT. jack of the unit, check that the pin is | Cable |
|
not bent. If it is bent, straighten the pin as illustrated, then plug the pin into the |
| |
ANT. jack of the unit. | Plug |
|
(Needs to be | (Straight pin) | |
| straightened) |
|
VHF/UHF COMBINED ANTENNA
A VHF UHF 75 ohm combination antenna can be connected to ANT. jack of the unit.
VHF/UHF SEPARATE ANTENNAS
In some areas it will be necessary to use an outdoor antenna.
CABLE WITHOUT CONVERTER/ DESCRAMBLER BOX
Use this connection if your cable system connects directly to the unit without a converter box.
CABLE WITH CONVERTER/DESCRAM- BLER BOX OR SATELLITE BOX
If your cable service supplies you with a converter box or if you use a satellite system, you can use the basic connection shown above.
Channel selection must be made with the converter box or satellite box. This means that channels cannot be changed using the remote control of this unit.
NOTE:
•For your safety and to avoid damages to the unit, unplug the antenna cable from the ANT. jack before moving the unit.
- 12 - | EN |