Sylvania LC195SL9C owner manual 5Channel List, Enter

Note:

•After setting “Auto Channel Scan”, using [CH K/L] on the remote control skips unavailable programs automatically.

•If you connect the cable system directly, contact the CATV installer.

•If you press [POWER] or [SETUP] during auto channel scan, the setting will be canceled.

•Channel settings will be saved even if the power fails.

•Even if “Autoscan“ is completed, the channel setting will be lost if the AC power cord is unplugged before turning off the unit by pressing [ENTER].

The channels selected here can be skipped when selecting the channels	INTRODUCTION
5Channel List
using [CH K/L].
Those channels can still be selected with [the Number buttons].	PREPARATION
1 Press [SETUP] to display the main menu.
2 Use [Cursor K/L] to select “CHANNEL”, then press	INITIALSETTING
[ENTER].
3 Use [Cursor K/L] to select “Channel List”, then press	WATCHING
[ENTER].	TV
Channell	OPTIONALSETTING
Autoscan
Channel List
Manual Register
Antenna

4 Use [Cursor K/L] to select the channel you want to		9	TROUBLESHOOTING
skip, then press [ENTER].
Channell Listi
Highlight channels for Ch	DTV	6
Up/Down key selection.		27
	DTV	8
	DTV	48
		58
	DTV	67	INFORMATION
Ch Select ENTER Watch/Skip	BACK
	Back
• The selected channel darkens in the channel list,
and it skips when selecting the channels by using
[CH K/L].
• To re-register the skipping channels, use [Cursor K/L]
and press [ENTER]. The registered channels will be gray
in the channel list, and you can select those channels
by using [CH K/L] again.
• When you skip a major channel, its minor channels
are skipped as well.

Note:

•The channel with “DTV” indicated on the display is ATSC. Otherwise the channel is NTSC.

5Press [SETUP] to exit.

19

EN