Sylvania SRPD442 owner manual Selecting the Input Signal, Displaying the Current Input Signal

SELECTING THE INPUT SIGNAL

POWER

VOL

MUTE

SCREEN MODE

STILL

INPUT SELECT

INPUT SELECT

DISPLAY

DISPLAY

The procedure for selecting the input signal described here is for use with the remote control. However, the INPUT SELECT button on the plas- ma display can also be used in the same way.

Displaying the Current Input Signal

1 Press the DISPLAY button.

The name of the current input terminal is dis- played on the screen.

2 To clear the name of the current input terminal, press the DISPLAY button again, or wait for approximately 4 seconds.

NOTE:

•To redisplay the name of the input terminal, press the DISPLAY button again.

Selecting the Input Signal

1 Press the INPUT SELECT button to select the input signal.

Each time you switch the input signal, the name of the selected input terminal is dis- played on the display for approximately 4 sec- onds.

The INPUT SELECT button cycles through the input terminals in the following pattern:

Video 1	Video 2	Component 1
(S-Video 1)	(S-Video 2)
			DISPLAY
	Component 2
NOTE:
• When switching the input signal, audio mute turns			PLASMA
ON temporarily.
• S-VIDEO1 takes preference over the VIDEO 1
jack, as does S-VIDEO 2 over the VIDEO 2 jack.
Therefore, if there is input to the VIDEO and S-
VIDEO terminals at the same time, the S-VIDEO			THE
signal is displayed on the screen. If the S-VIDEO
cable is not connected to the plasma display, the			OPERATING
VIDEO signal will be displayed on the screen.
• 480i (interlaced) signals can be connected to the
COMPONENT 1 and 2 terminals. Any of the fol-
lowing display formats: 480i, 480p (progressive),
1080i, and 720p (progressive) signals can be con-
nected to the COMPONENT 2 terminal. If one of
these video signals is detected, the format of the
input signal is displayed after the name of the cur-
rent input terminal, as in the following manner.
• A "No signal" message appears if there is no video
signal, and there is no message currently dis-
played on the screen for volume adjustment or the
setup menu, etc. If there continues to be no video
signal for more than 10 seconds, "No signal" slow-
ly moves around the screen.
• If there is no video signal, and there has been no
operation from the remote control or the buttons
on the main unit for more than 15 minutes, the
auto shut-off function activates, and the display
switches to standby mode.

11