Sylvania SSL2606 Channel Settings Autoscan, Initial Settings / Channel Settings, Press Enter

CHANNEL SETTINGS

AUTOSCAN

If you switch wires (e.g. between antenna and CATV) or if you move the TV to a different area after the initial setting, you need to perform Autoscan again. This function lets you easily select the receivable channels with [CH K/L] and the TV memorizes them even if you switch wires.

		STILL
-	0
SETUP		SCREEN
		MODE
	ENTER
BACK		INFO
	CH RETURN
VOL.	MUTE	CH

NOTE:

•Make sure the TV is connected to antenna or cable.

1Display the setup screen.

•Press [SETUP].

The following setup screen is displayed.

3For TV channels, using [K/L], select “Air”. For CATV channels, select “Cable”.

Autoscan
Autoscan will rescan all channels.		Back
This may take a while to complete.		Air
Select the destination of "ANT IN" jack.		Cable
Air		Cable
		1hour
Cable	Or
	ANT IN

•Press [ENTER].

Scanning and memorizing the channels auto- matically starts.

Now the system is scanning for channels, please wait.

72%

Analog channels		10ch
Digital channels		6ch
SETUP	Exit

•When the scanning and memorizing are com- pleted, the lowest memorized channel in the broadcasting will be displayed.

NOTES:

•If you connect a cable system directly, contact the CATV installer.

•If you press [POWER] or [SETUP] during Autoscan, this setting will be canceled.

•If there is no reception connected or poor signal is detected, a Hint will appear on screen once scanning stops.

INITIAL SETTINGS / CHANNEL SETTINGS

2Select “CHANNEL” and press [ENTER] to con- firm.

• Using [K/L], select “Autoscan”.

Channell

Autoscan

Channel List

Manual Register

Antenna

•Press [ENTER].

13

EN