Cutting Attachment Shield Assembly
WARNING!
NEVER operate this machine without the cutting attachment shield. Operating without the cutting
attachment shield may result in seri- ous injury.
(A) Cutting Attachment Shield
(1)Insert the cutting attachment shield between the outer tube and the lower clamp. Loosen the nut and bolt which are tightening the lower clamp if the cutting attachment shield does not fit with the lower clamp.
NOTE:
It may be necessary to loosen the lower
clamp bolt so that the shield will fit
between the tube and clamp.
(2)Fit the two spacers (T350 only) and the upper clamp over the outer pipe and tighten with four bolts.
NOTE:
Tighten four bolts a crisscross fashion.
(3)Tighten the lower clamp bolt and nut securely.
WARNING!
Carefully inspect the cutting attachment shield assembly to make sure it is tightened securely and
does not wobble.
BOLT | CUTTING |
ATTACHMENT | |
| SHIELD |
UPPER | OUTER TUBE |
CLAMP |
|
SPACER |
|
BOLT |
|
| SPACER |
NUT | LOWER CLAMP |
(B)Shield Extension (when trimmer head is in use)
(1)Attach the shield extension to the cutting attachment shield.
NOTE:
Make sure the shield extension is com- pletely hooked at the hook receiver.
CAUTION!
The line cutter is attached to the shield extension and must be used when op- erating with a trimmer head.
CUTTING ATTACHMENT SHIELD
HOOK RECEIVER
HOOK
SHIELD EXTENTION
10