Assembly of the Handle T350
WARNING!
NEVER operate this machine without the front handle. Oper- ating without the front handle may result
in serious injury.
NOTE:
Tighten four bolts diagonally to properly secure the handle.
NOTE:
Adjust the handle at the best position for operator comfort.
(1)Put four square nuts in the recess- es on the underside of the barrier.
(2)Fit the handle and barrier over the outer tube and tighten four bolts in a crisscross fashion.
HANDLE
OUTER TUBE
BARRIER
BOLT BARRIER
NUT
Assembly of the Handle C350/B450
(1)Loosen the two bolts of the lower cap and remove the lower cap.
(2)Position the handle bracket against the handle label located on the outer tube.
(3)Attach the lower cap with the two bolts and tighten the bolts. Make sure the front handle is in position per the illustration.
(4)Secure the cable to the outer pipe with the two bands as the illustration shows. The two bands are in the tool bag.
HANDLEBAR
HANDLE BRACKET | THROTTLE GRIP |
|
HANDLE LABEL
BOLT
LOWER CAP
BAND
Throttle Cable Adjustment
(1)Pull the throttle trigger gently, and check for
(2)If free-play is out of specifications:
(a)Slide the cable cap toward the muffler side until the adjusting nut and the lock nut appear.
(b)Loosen the lock nut slightly.
(c)Turn the adjusting nut so that
(d)Then, tighten the lock nut.
(e)Slide the cable cap back.
THROTTLE CABLE
CABLE CAP
ADJUSTING NUT
LOCK NUT