©Removing an accessory
From the 25-pin connector
1. Turn off the PTC-860.
2. To remove an accessory that connects directly to the PTC,
slide the accessory’s locking latch as far to the left as it wi ll
go and loosen the PTC’s locking screw.
3. Pull the accessory or the cable’s connector directly away
from the PTC’s 25-pin connector.
Do not pull at an angle.
Do not use a rocking or twisting motion when pulling the
connectors apart.
From the wand port (PTC-860 only)
1. To remove a bar-code reader from the PTC-860, insert the
tip of a pen or pencil into the opening at the to p of the
bar-code reader plug and press down firmly. (A release on
the plug should be activated, allowing the plug to be
removed.)
2. Firmly pull the bar-code reader plug from the wa nd port.
3. Replace the wand port’s protectiv e plug.
34