6. If you are connecting an accessory directly to the PTC,
tighten the PTC’s locking screw and slide the accessory’s
locking latch as far to the right as it will go to lock the
accessory onto the PTC.
If you are connecting a cable, connect the other end to the
accessory using the same procedure.
Through the wand port (PTC-860 only)
1. Before attaching a bar-code reader to the PTC-860 , remove
the protective plug from the wand port by placing the tip of
a small screwdriver between the plug and the PTC and
gently prying the plug from its port.
2. Line up the bar-code reader plug with the PTC-860’s wand
port and press the plug into the port until it sn aps into
place.
FIGURE 4
Using the accessory locking latch
LOCKING LATCH
33