System Sensor DH500ACDC specifications B A, E, D500-07-00 6 I56-432-11R

D500-07-00

6

I56-432-11R

	1	2	3			ACCESSORY CURRENT LOADS AT 24VDC			Figure
						DEVICE	STANDBY	ALARM	5
						PA400	0mA	15mA MAX	.
			K2		120 VAC				Wiring
NOTE: JUMPER WIRE (J5)		J5				RA400Z	0mA	10mA MAX
IS REQUIRED TO BE	4	5	6 7 8	9 10 11 12 13	14 15 16 17	RTS451/RTS451KEY 0mA *		10mA MAX *
INTACT FOR 2-WIRE
APPLICATIONS ONLY.						ANY COMBINATION OF ACCESSORIES MAY BE USED			diagram:
CUT J5 FOR 4-WIRE	+	–				SUCH THAT THE GIVEN CURRENT LOADS TOTAL:
POWER SUPERVISION.						STANDBY STATE: 30mA OR LESS
			24 VAC &		240 VAC
						ALARM STATE:	80mA MAX, 24 VDC (TERMINALS 3 & 6)
			24 VDC
							20mA MAX, AUXILIARY ALARM OUTPUT (TERMINALS 2 & 6).
			ALWAYS RUN AUXILIARY CONTROL
				WIRING IN SEPARATE CONDUIT		*NOTE: WHEN INITIATING AN ALARM, THE RTS451/RTS451KEY REQUIRES
COMMUNICATION (+)			(+)	COMMUNICATION	NOTE: FOR POWER SUPPLY	95mA MAXIMUM IN PRE-ALARM AND 103mA MAXIMUM IN ALARM.
						NOMINAL STANDBYCURRENT IS 0mA. ALARM CURRENT IS 8mA
LINE				LINE TO REST	WIRES, POLARITY IS NOT
						MAXIMUM WHEN TEST MAGNET IS REMOVED.
FROM PANEL	(–)			(–) OF SYSTEM	IMPORTANT.

Figure 5B

Figure 5A

2	1
ALARM SIGNAL (+)
		R
6	2	E	2	(+)	2	(+)
AUX POWER (–)		D
			ALARM SIGNAL (+)		ALARM SIGNAL (+)
	3	RESET
		(NOT USED)	AUX POWER (–)		AUX POWER (–)	RED
3
	4 TEST (+)		6	(–)	6	(–)
AUX POWER (+)
1	5 TEST (–)
TEST (–)			DUCT DETECTOR	PA400 (OPTIONAL)	DUCT DETECTOR	RA400Z (OPTIONAL)
			DH500ACDC	AUDIBLE ALERT	DH500ACDC	REMOTE (LED)
DUCT DETECTOR	RTS451/RTS451KEY					ANNUNCIATOR
DH500ACDC	(OPTIONAL) REMOTE
	TEST STATION		Figure 5D		Figure 5E
NOTE: THE RTS451 RESET CANNOT BE USED ON THE DH500ACDC.

Figure 5C

H0310-00

NOTE: Auxiliary devices (RA400Z, PA400, RTS451/RTS451KEY) and auxiliary control contacts will not function without auxiliary power. See Figure 5A for voltage/termination.