T+A Elektroakustik DD 1535 R manual Speakersizemenu, Mainspeaker, Centerspeaker, Surroundspeaker

Speakersizemenu

In the 'Speaker size menu' you initially adjust the output signals to suit the existing loudspeaker system.

To avoid the loss of any sound information in systems where not all the loudspeakers (centre, rear and sub- woofer) are present, the missing components must be marked as none in the 'Speaker size menu'.

The corresponding sound signal is then distributed over the channels which are present (Downmix).

Select menupoint

Change

value

Speaker size
					satellite				full range
Main speaker		rull range		none			satellite
Center speaker		full range
				none			satellite
Surr. speaker		full range
Back speaker		2 full range		none			1 satellite
5.1 surnd SPK		Surnd+Back		1 full range					2 full range
Subwoofer		none
Satellite high pass		80 Hz		Surnd				Back
return to Loudspeaker menu				none
￿ / ￿ /	/	/ STOP	50		60	70	80	90	100

OK

Mainspeaker:

Defines the size and bass capacity of the main left and right front loudspeakers. Select one of the following settings:

Satellit for small speakers whose bass reproduction is necessarily restricted. The low bass content (below the set transition frequency) of the main channel signals is mixed down onto the subwoofer, if present.

fullrange for larger speakers. The full frequency range is passed on to the main speaker channels without restriction.

Centerspeaker:

Defines the size and bass capacity of the center speaker. Select one of the following settings:

none if no center loudspeaker is present. The center channel is mixed down onto the left and right main loudspeakers.

Satellit for small centre loudspeakers. The low frequency bass signals of the centre channel (below the set transition frequency) are mixed onto other suitable loudspeakers and, if present, the sub- woofer.

fullrange for a center speaker of about the same size as the main loudspeakers. The full frequency range is passed on to the center channel without restriction.

Note:

If your system does not include a center speaker, the main loudspeakers should be set up not too far away from the TV set, and ideally should be arranged symmetrically about it, otherwise it will be very difficult to localise dialogues on the television screen.

Surroundspeaker:

Setting the size and bass capability of the surround loudspeakers. Select the settings as follows:

none	if no surround loudspeakers are present.
	The surround channels are mixed down
	onto the left and right main
	loudspeakers.
	for small surround loudspeakers. The low
Satellit
	frequency bass signals of the surround
	channels (below the set transition
	frequency) are mixed by the bass
	manager onto other suitable loud-
	speakers and, if present, the sub-woofer.
	if the bass reproduction of the surround
fullrange
	loudspeakers is very good. The full
	frequency range is reproduced by the
	surround	loudspeakers	without
	restriction.

Note:

Genuine surround reproduction is not possible without surround loudspeakers!

18