OPERATION AND MAINTENANCE
Portable Power Source Features
The Truck PAC provides plenty of power for starting vehicles – more than enough to start most cars, vans, SUVs, light trucks and delivery vehicles.
The Truck PAC will power most 12 Vdc accessories equipped with a male 12 Volt outlet plug (12 Volt Model ES6000 only). The DC outlet features automatic overload protection.
The unit features a test switch and LED lights. State of the art circuitry allows the unit to remain continuously connected to the charger without the risk of overcharging.
Safety Features
Safety storage holsters prevent accidental sparking of clamps and rotate 90° for easy clamp removal and replacement. Always
Cable grooves lock the cables for clean storage (no hazardous or unsightly dangling wires). Always
The Truck PAC contains the latest technology with its 12 Volt sealed,
RECHARGING PROCEDURES
Note: Upon initial purchase, your Truck PAC should be charged for a minimum of 30 hours.
Figure 2. Test Button, Charging, Power Levels and Charge Complete LEDs
Recharging Your Truck PAC
There are two ways to charge your Truck PAC. The recommended method is automatic charging with the provided wall charger. An alternative method is through the DC power outlet using the provided 12 Volt
Charging using the supplied wall charger (recommended method). This is the recommended charging method because it features automatic charging, eliminating the possibility of overcharging. With this method, the wall charger is connected to the Truck PAC through a small charging jack (pin jack), located on the rear of the unit. Recharging takes approximately 4 to 6 hours for each light that does not come on when the test button is pressed. With this method, your Truck PAC can be left connected to the wall charger indefinitely. This is the only method for charging Model No. ES8000.