T-Tech ES6000, ES8000 user manual Testing The Battery, Battery Removal And Disposal Instructions

TESTING THE BATTERY

After fully charging the battery so all red lights come on, apply a 100 amp load to the vehicle charging plug (on the Truck PAC), for a period of 6 seconds, while monitoring the battery voltage (at the vehicle charging plug). The battery is good if the voltage is 9.5 Vdc or higher.

BATTERY REMOVAL AND DISPOSAL INSTRUCTIONS

Pb

CONTAINS SEALED LEAD-ACID BATTERY. BATTERY MUST BE RECYCLED.

The battery inside this product is a sealed lead-acid battery. It is required by law to be removed and recycled or disposed of properly. While there are federal regulations that must be complied with throughout the United States, your individual state or local governments may have additional regulations to be followed.

When the battery in this product is in need of replacement, remove it according to the instructions provided below and take it to your local recycling center for proper recycling or disposal. If you don’t have a local recycling center that handles sealed lead-acid batteries, contact your local environmental agency for instructions.

Removal Instructions

Begin by making sure that both clamps are securely stowed in their holsters on each side of the Truck PAC.

1.Lay the Truck PAC down on its front. Locate the 13 screws that hold the case together (four on the left edge, four on the right edge, four along the bottom and one under the front label).

2.Remove the 13 screws, then lift off the back half of the case.

3.On the top of each battery are two terminals, each with wires connected to them. Disconnect these wires from the top battery first, by removing the bolts that hold them to the battery terminals. Disconnect these wires from the bottom battery by removing the bolts that hold them to the battery terminals. To prevent accidental arcing, be careful not to touch both battery terminals with the tools being used to remove the bolts.

4.Lift the batteries out of the front half of the case.