44 programming the system remote
Programming the system-remote control
programming the system remote 45
learning new commands
R E M O T E S E L E C T I O N
The
•
•
•dvd player DVD32FLR and DVD32R
Other devices which are not
To ‘learn’ new commands:
1. | Select the device you wish to program by pressing the appropriate |
| REMOTE SELECTION key on the |
2. | Place the |
| control on a flat surface. Line up the remote controls head to head, |
| about 5 to 10cm (2 to 3in) apart. |
3. | Simultaneously press and hold the REMOTE SELECTION key |
| selected in step 1 and the ok key for about four seconds. The |
| learning status LED will turn yellow to indicate that the Remote is |
| now in learning mode(1). |
4. | Press and release the key on the |
| program(2). The status LED will flash yellow. |
5. | Press and hold for approximately three seconds the key on the |
av | cd | dvd | amp |
sat | tv | vcr | ld |
return |
|
| record |
skip |
|
| LFE |
+ |
| pause | + |
|
| ||
| r | ok | f |
| e | play | f |
| w | d | |
| stop | ||
skip |
|
| LFE |
cancel |
|
| eject |
| R E M O T E S E L E C T I O N | ||
av | cd | dvd | amp |
programming the system-remote
Some devices (other than those listed above) may partially work with the
| R E M O T E S E L E C T I O N |
| |
av | cd | dvd | amp |
sat | tv | vcr | ld |
original remote control which corresponds to the function you want |
the |
green if the code is correctly understood. If it flashes red then you |
need to restart with step 4 as the code was not understood by the |
remote. |
6. Release the key on the original remote and |
approximately a further three seconds. If the learning process has |
been successful, the status LED will flash green twice, then return to |
yellow. If the LED flashes red you need to restart with step 4 as the |
code could not correctly be interpreted by the remote. |
sat | tv | vcr | ld |
Repeat steps 4 through 6 to program further keys.
1.The Remote will stay in learning mode for 20 seconds, after which it will return to normal operation mode if there have been no further key presses
2.The macro keys m1 to m4 can be programmed with new commands, but if they are used for the macro feature (see ‘programming macro features’) the new command will be