TAG DVD32FIR Erasing single commands, Erasing all commands for one device, Remote control warning

48 programming the system remote

erasing single commands

programming the system remote 49

erasing all commands for one device

To erase a learnt command from a key:

	av
1. Simultaneously press the REMOTE SELECTION key for the appropriate	sat
device and the ok key until the status LED turns yellow and the chosen	skip
	return
REMOTE SELECTION key is lit.	+
2. Press the key for the function which you wish to erase. The REMOTE
SELECTION LED will turn off and the status LED will flash continuously	---
yellow.	skip
	cancel

3.Press the light key. The status LED will flash green twice then turn a constant yellow colour. The chosen REMOTE SELECTION key LED will turn back on.

Repeat steps 2 and 3 to erase any other learnt commands for the selected device.

4.To finish, simultaneously press and hold the REMOTE SELECTION and ok keys. The REMOTE SELECTION key LED will go out and the status LED will flash yellow twice then go out.

R E M O T E S E L E C T I O N
	cd	dvd	amp
	tv	vcr	ld
			record
			LFE
	pause		+
r	ok	f
e	play	f
w		d
	stop		---
			LFE
			eject

light

To erase all learnt commands for one device:

1.Press the REMOTE SELECTION key for the appropriate device and the ok key simultaneously until the status LED turns yellow and chosen REMOTE SELECTION key is lit.

2.Press and hold the light key. The status LED will flash red five times and the selected devices LED will turn off. Release the light key; the status LED will flash green twice then turn a steady yellow and the selected device key LED will turn on again.

3.To finish, press and hold the REMOTE SELECTION and ok keys simultaneously. The REMOTE SELECTION key LED will go out and the status LED will flash yellow twice then go out.

erasing all commands for all devices

To erase all learnt commands for ALL devices:

1.Press and hold the tv REMOTE SELECTION and light keys simultaneously. The status LED will flash red 10 times, then green once, yellow once and turn off(1).

erasing a macro function

To erase a macro function:

1.Simultaneously press the appropriate REMOTE SELECTION key (av or sat) and the mute key until the learning status LED turns red.

2.Press the macro key (m1 to m4 or standby) you wish to erase.

3.Press the CH + (or CH -) key. The learning status LED will flash red twice then go off.

remote control warning

You will, from time to time, have to replace the batteries in your system-remote. During the battery changing operation the Remote will remember your programmed commands, but you should avoid pressing any key on the Remote during battery changing as you may lose all your stored settings.

1.Caution – this will erase every function that you have programmed into the Remote