TAG DVD32FIR manual programming the system remote, learning new commands cont’d

46 programming the system remote

learning new commands (cont’d)

7.Once you have finished teaching the system-remote all the desired commands from the original remote, you must store them by simultaneously pressing the appropriate REMOTE SELECTION key and the ok key for about four seconds.

Once you have stored the ‘learnt’ functions, test the keys you have taught to make sure that they are programmed correctly.

If the system-remote has problems learning from the original remote(1),you should:

programming the system remote 47

Macros can only be programmed with either av or sat selected! Macros programmed under av will be recalled, pressing m1, m2, ...

m4 or standby, when you use av, cd, dvd, or amp. Macros programmed under sat will be recalled when using sat, tv, vcr and ld.

When using the macro functions, it can take up to 10 seconds to transmit a 10-key sequence. You should keep the system-remote pointing towards the appropriate unit while the commands are being transmitted to ensure they are received correctly.

programming a macro function

•check that the original remote has fresh batteries

•avoid fluorescent lights and strong sunlight, which may interfere with the learning process

•increase or decrease the distance between the two remote controls (within a range of 2 to 15cm / 1 to 6in)

To program in a macro function:

1. Simultaneously press the REMOTE SELECTION key for the set of

macros you wish to program (av or sat) and the mute key. The

learning status LED and the REMOTE SELECTION key will both

	R E M O T E S E L E C T I O N
av	cd	dvd	amp
sat	tv	vcr	ld

mute

programming macro features

The keys m1 to m4 and standby can act as macro keys. These can be programmed to store up to 10 commands to send together with one key press. Any key press function (except mute, CH + and CH –) can be programmed into the macro keys. There are 2 groups of macros, one used if the av, cd, dvd or amp remote selection keys have been pressed, the other for the sat, tv, vcr or ld keys; i.e. there are a total of 10 macros available.

tv	vcr	sat	tuner	aux
cd	ld	dvd	md	dab

m1 m2 m3 m4

light

	turn red to indicate that the Remote is in macro learning mode(1).
2.	Press one of the macro keys m1 to m4 or standby to which you
	wish to allocate the functions.
3.	Press the keys for the commands (up to 10) you want stored in
	the macro key(2).
4.	Press the CH + (or CH -) key to store your selections. The
	learning status LED and the REMOTE SELECTION key will both
	flash red twice, then go out.
5.	To use the macro, simply press the macro button.

tv	vcr	sat	tuner	aux
cd	ld	dvd	md	dab
m1	m2		m3	m4
		light

+	+
V O L	C H

--- ---

1.Some remote controls operate at non-standard infra-red, UHF or ultrasonic frequencies, and cannot be learnt; this is sometimes also caused by unusual or complex functions which are not universally recognised. If you continue to experience problems programming the system-remote, please consult your retailer for advice

1.The Remote will stay in macro learning mode for 20 seconds, after which it will return to normal operation mode if there have been no further key presses

2.You can select functions to control another unit as part of a macro by first pressing the appropriate REMOTE SELECTION key before pressing the keys for the desired functions. This REMOTE SELECTION key press counts as one of the 10 presses you may store in the macro key