| Owner’s Manual |
|
This
I. ASSEMBLING PROCEDURES
NOTE: Prepare two 10mm wrenches for assembling.
1.First, remove gear case assembly from your brush cutter by removing pipe tightening screws (1) and pipe lock screw (2), then remove safety cover of brush cutter. (Fig. 1)
2.Install safety cover (3) and the collar (4) of
3.Install
4.Once the unit is completely inserted, meet the locking hole of pipe and that of gear case, tighten the lock screw (7) in the hole and pipe tightening screws
(8)in order. (Fig. 4)
NOTE: After installation, you can not turn tines by hand due to its worm gear mechanism.
5. Finally secure the safety cover a minimum of 2 in. from the gear case.
NOTE: If your unit is model
II.OPERATING PROCEDURES
1.As to general safety operation and power head operation such as engine starting/shut off, etc, please refer to the owners manual provided with your Tanaka brush cutter.
2.How to till:
a. For standard tilling. Walk forward as pulling and pushing the unit little by little like using a vacuum cleaner. (Fig. 5) When you want to erase your
| 1 |
|