Installation of blade guard (Fig. 1-7)
1)Install blade guard (1) on gear case (4) temporarily by clamping with guard brackets (2) and screws (3). Then tighten as needed.
2)Line up the slot of guard bracket (2) with the same of gear case (4), then tighten screws
(3) securely. (Fig.
Installation of wheel (Fig. 1-7C)
1)Installation the wheel as the illustration.
2)After installation, check if the wheel turns smoothly.
Installation of blade (Fig. 1-8)
1)Before installation of blade, take off left hand threaded fixing nut (1), cutter holder cap (2) from the blade shaft.
2)Install blade (3) on the shaft and then replace the cutter holder cap and fixing nut in order.
NOTE!
When installing cutter holder cap (2), be sure to set concave side facing blade.
3)Insert the locking bar (4) into the hole of the cutter holder (5) and gear case by lining up each hole.
4)Tighten the fixing nut securely (clockwise to
5 |