Configure the Gateway | TANDBERG Gateway |
|
|
Encryption
The gateway will allow DES and AES 128 encrypted conferences to take place. Encryption can operate in two modes.
NOTE WHEN ‘ENCRYPTION’IS ENABLED, THE CAPACITY OF THE GATEWAY MAY BE REDUCED. SEE APENDIX 3 FOR MORE INFO.
When set to Transparent, the Gateway will forward the encryption modes of the connected devices transparently. The encryption modes seen on each side of the Gateway are similar. The gateway will only encrypt calls if both sides support encryption. The settings for H.320 and H.323 doesn’t have any meaning in this mode.
When set to Independent, the Gateway will use the settings made for the H.320 (ISDN) and H.323 (IP) side. The encryption modes on each side of the Gateway are independent of each other. One endpoint might show that the call is encrypted will the other endpoint shows an unencrypted call.
On Encryption is required. Gateway connection is only established if encryption can be established on this side.
Off No encryption. Gateway connection will be established without any encryption on this side.
Auto Use encryption if available. Gateway will try to establish an encrypted connection, the connection will be established regardsless if encryption on this side is available.
A typical application of this feature is when an external crypto device is used on the ISDN interface. In this case might an administrator want to set the Gateway’s encryption on the H.320 side to Off and on the H.323 side to On.
H.264
Allows H.264 video capabilities to be transmitted through the gateway. When disabled no H.264 video capabilities will be transmitted.
Save
Press ‘Save’ to activate the new settings.
58
