Tanita HD-351BT Operation without Bluetooth, Instructions for Use, Operation with Bluetooth

5.Switch The Weight Mode Note: For use only with models containing the weight mode switch The units can be changed using the switch on the back of the scale as shown in the figure.

6. Operation without Bluetooth

Instructions for Use

Tap the personal key with your toe.

The display will show personal number (Fig.3).

Wait for the display to show "0.0" (Fig.4), then step on the scale (Fig.5). Current reading in upper display and previous reading in lower display.

Note : • OL will appear on the display when the scales weight capacity is exceeded.

•"0.0"disappears if you do not step on the scale within 60 seconds.

•The unit will shut off if you tap the OUTPUT key, except --- while measuring.

Fig.3 Fig.4 Fig.5

7. Operation with Bluetooth

Initial Pairing

1-1) Before activating the scale, make sure the corresponding Bluetooth device is turned on.

1-2) Press “OUTPUT” key to turn on the scale, as noted by a single beep.

	1-3) Within 30 seconds, activate the communication sequence within the Bluetooth device to initiate
OR	the pairing process with the scale. If 30 seconds is exceeded an error message will appear and
	the process must be repeated (press the “OUTPUT” key).

1-4) The pairing process is completed on the corresponding Bluetooth device and the scale, as noted by a double beep.

1-5) The display will change to the zero calibration display.

1-6) The display will then change to the waiting display. Step onto the scale and measure weight.

1-7) The weight result will flash after measurement is completed. The weight data will then be sent to the corresponding Bluetooth device.

1-8) To continue with more weighting’s, press “OUTPUT” key (return to step 1-5).

1-9) The scale will automatically shut off when ---

*The user remains on the scale for 30 seconds.

*The user get off from the scale, and then after 30 seconds.

2 3