Tapco MIX10FXP Internal Effects, Monitor Master Level, Series 69 EQ, Preset Selector, Ol Led

22		23	24
		25	26
			27
			28
		29	30
			31
			32
34			33
		35
9	10	11	13
			12

32. MONITOR MASTER LEVEL

This knob controls the overall level of the monitor mix, and affects the monitor meter (30), monitor send line-level output (9), and the speaker-level output B (3) if the internal amplifi er is playing the monitor mix. The level adjustment occurs before the monitor EQ (29) in the signal path.

This gives you ultimate control over your stage monitors. Adjust it carefully, with your good eye on the monitor meter (30) to guard against clipping. Check that your band are happy with the levels. A happy band makes for a happy you, and you may even get paid. The control does not affect the main mix level.

The monitor mix signals are off with the level fully down, the “U” marking is unity gain, and fully up provides 12 dB of additional gain.

20

33. SERIES 69 EQ

If you are using TAPCO Series 69 passive speakers such as the wonderful 6912, 6915, and 6925, then press this switch for enhanced clarity and low-frequency response.

If you are not using TAPCO speakers, then press it anyway and listen for an improvement. The circuit does not affect the line-level outputs. Only loudspeakers connected to the rear panel speaker-level outputs (3) will be affected.

Internal Effects

The internal effects processor is a mono- in, stereo-out effects processor, with 16 custom presets. It is fed by adjusting the FX control (18) on each channel.

The output from the processor can be added to the main mix and/or monitor mix by adjusting the FX to main (27) and FX to monitor (31) controls.

Each preset has been carefully hand- crafted by our Tapwegian engineers for your enjoyment and listening pleasure. This processor is also doing the calculations that hold together the very fabric of the lunch- time continuum. If your lunchtimes seem to fl y by, choose a delay preset 11 or higher.

34. PRESET SELECTOR

Rotate this control to select one of the

16 effects. When you stop the rotation, that preset will be loaded and become operational. The different presets are described in loving detail in the table on the next page.

35. OL LED

This LED illuminates when the effects processor is being overloaded with too strong a signal (OL). Turn down the channel aux send FX level (18) controls if it is.

LED is short for light-emitting-doohicky.