Open the USB cable compartment (Figure 3), uncoil the cable, and plug the USB connector into the USB port of your computer.
LED Status Indicators
Once you connect the port replicator to the computer and turn on the computer, the LED lights display as follows:
vThe Hub Link and both USBs glow green.
vThe serial (RS232) and parallel ports glow green when devices are attached.
vThe PS/2 port lights flash green when a device is first connected or there is activity on the ports.
vThe Tx/Rx light flash green when data is transmitted to or from the network.
vThe 100M light glows green when attached to a 100 Mb hub.
NOTE: The Ethernet port is compatible with 10 or 100 Mb networks, however, the USB connection determines the actual network speed.
SOFTWARE INSTALLATION
This section explains how to install the drivers to support each port on the port replicator. If your computer is off, turn it on now.
For the initial installation, you must install the software drivers for each port and enable them for use. Do not skip any of the following procedures.
NOTE: The sequence in which Windows detects and installs the software drivers for each port may vary depending on the model of your computer.
If you are running Windows 98, you may need your Windows 98 CD to complete the installation. During the installation, you may be prompted to insert the CD.
If you are running Windows 2000, you will only need the included Targus driver diskette. Also, you will see the message Digital Signature Not Found Do You want to continue installation? Y/N after each port is detected. Click Y to continue driver installation.
3
