7 – Cassette operating

2 Press the EJECT key to open the cassette compartment door.

3 Load the cassette tape with its open edge facing down.

4 Gently close the compartment door.

NOTE

The cassette holder cannot be opened during recording or playback.

If the power has been switched off during play or recording, ejecting the cassette may be impossible. In such a case, switch the power on and press the EJECT key again.

Note the following when loading tapes:

1Use your finger or a pencil to turn the cassette's hub and take up any slack tape.

NOTE

Avoid touching the tape. Fingerprints attract dust and dirt.

Playback operations

WARNING

If you are monitoring using headphones, first adjust the level control to low on the unit, then connect to the POHNES jack before playing back. This will prevent any possible damage to your hearing.

1Set the REV MODE switch to the required tape mode.

ÄSingle-sided playback

ËOne side, then the other side, then stop

äOne side, then the other side, then the first side again, etc.

Also, check the monitor switch is set to tape.

2Load a pre-recorded cassette with its open edge fac- ing down and side A facing toward you.

3Set the DOLBY NR system on or off.

4Press either PLAY key to start playback.

5Adjust the volume with the amplifier’s volume control.

6 To stop playback, press the STOP key.

Continuous tape/CD playback

1Load the tape as described above into the unit.

Load the disc recorded side downwards into the unit.

2Press the CD-TAPE CONT PLAY key.

3Press either of the PLAY keys of the tape deck or the

CD deck.

Playback will start on the appropriate unit. When playback reaches the end of the disc, or the end of the tape as determined by the REV MODE setting, playback starts on the other unit.

NOTE

Media (tape or disc) can be changed in the unit that is not playing.

4To stop playback and cancel the mode, press the

CD-TAPE CONT PLAY key again.

NOTE

The cassette deck and CD deck can be used to play back through different outputs, or the LINE OUTPUTS 2 jacks can be used for both disc and tape playback (see “OUT2 setting (TAPE or AUTO)” on page 32 for details). However, note that if both are playing, the cassette takes priority (the disc will not be heard through these outputs).

The LINE OUTPUTS1 jacks always output the audio from th edisc.

TASCAM CC-222SL 29