| 8 – Reference and specifications |
|
|
|
|
Error messages |
|
|
|
Message | Details / Response |
Cannot Rec! | Use unfinalized recordable disc. |
Disc Error! | The unit may ejects the loaded disc. If it is |
| (“Refreshing a disc” on page 28), or replace disc. |
Disc Full !! | There is no space on disc, or no tracks are available. |
Drive Error! | There is problem with the Drive mechanism. |
Digital input is not connected. Turn on power of source unit and | |
| connect to DIGITAL IN. |
Cannot ERASE! | The data cannot be erased. |
Erase Error! | An error has occurred while trying to erase disc. |
Not Fs 44.1k! | The sampling frequency of digital input is not 44.1kHz. |
| Please turn SRC on (“Frequency conversion” on page 20). |
PGM Full ! | An attempt has been made to create more than 99 tracks. |
Rec Error | A general recording error. Try recording again with different disc. |
| The unit may ejects the loaded disc. |
System Err! | System Error. Try turning the power off and on again. |
Eject Error! | There is a problem with the disc slot. |
| |
Messages displayed during normal operation | |
|
|
Message | Statement |
Complete | An operation such as finalize or erase has been successfully completed. |
Now OPC | Calibration is being performed to operate recording properly. |
Now REPAIR | The disc is being repaired and this operation will take a long time. |
| Please do not turn off power of the unit until it finishes. |
PMA Writing | Recorded content is being written to disc. |
TOC Reading | Table of contents data is being read. |
REC Standby | The unit is in recording standby mode. |
Blank Disc | A blank recordable disc has been inserted. |
NO DISC | A disc is not loaded into the unit. |
TASCAM