2 • Features of the CD-RW700—Connections
FSYNC REC key
Use this key to turn synchronized recording on and off (equivalent to L). See 4.3.1, “Synchronized recording” for details).
GREC MUTE key
Use this key when recording, to mute the input signal for about four seconds and then to enter record ready mode (see 4.3.5, “Rec mute function”).
the batteries should match the + markings inside the battery compartment, and the negative termi- nals should match the – markings).
•If you are not going to use the remote control unit for an extended period of time, remove the batter- ies. Old batteries can leak, casing damage to the remote control unit.
•Always dispose of old batteries in the way recom- mended by your local garbage disposal authorities.
HSEARCH keys
Use these keys to move the playback position inside a track.
ISKIP keys
Use these keys to move between tracks when playing back (equivalent to turning B). They are also used to set the parameter values, etc.
JSTOP key
Use this key to stop playback or recording (equiva- lent to H).
KPAUSE key
Use this key to pause playback or recording (equiva- lent to J).
LPLAY key
Use this key to start playback, or enter record mode from record ready mode (equivalent to I).
2.3.1Use of the remote control unit
When using the remote control unit, make sure:
•There is a clear unobstructed path between the remote control unit and the remote sensor 7 on the main unit.
•The remote control unit is located within 5 m
(15 ft.) of the main unit, and is pointing at approxi- mately right angles (±30°) to the front panel.
When fitting or replacing the batteries:
•Always make sure that both batteries are replaced together. Do not mix old and new batteries.
•Do not mix batteries of different types.
•Always make sure that the batteries are located with the correct polarity (the positive terminals of
2.4 Connections
The following should be noted when you connect the unit to other equipment.
It is possible to connect the unit’s DIGITAL COAXIAL IN P and DIGITAL OPTICAL IN Q to other equipment at the same time. However, the unit can receive signals from only one digital input at a time.
Audio signals output from the unit are output from the ANALOG OUT O jacks, as well as from the DIGITAL COAXIAL OUT jack P and DIGITAL OPTICAL OUT connector Q simultaneously.
If the ANALOG IN jacks N are connected, it is pos- sible to select a “mix mode”, where the ANALOG IN signals are mixed with the digital audio signals at either the COAXIAL or OPTICAL input. The digital audio signal is attenuated (cut) by 12 dB when this mix takes place.
2.5 Timer operations
The unit can use its internal clock to start and stop playback or recording at
2.5.1Setting the clock
1When the unit must be in standby mode (power connected but not turned on), and if the time has not been set, the display shows Clock Adjust in dimmed characters.
2Press the MENU key (9 or 7). The display lights, and shows CLOCK ADJ ?.
3Press the MULTI JOG control B or the ENTER key on the remote control unit 8. The “hours” value will start flashing.
4Turn the MULTI JOG control or use the remote control unit SKIP keys I to set the current
hour.
TASCAM
