3 − Playback

Continuous playback

3

Continuous playback can be performed between TAPE 1 and TAPE 2. When one tape is played back to the end, the other tape automatically starts playback, in a relay fashion.

1.Load pre-recorded tapes into the TAPE 1 and TAPE 2 compartments.2.Set the DOLBY NR switch.

Always set the DOLBY NR switch to the same position that was used for recording.

3.Set the REV MODE switch to the ä (CONT PLAY) position.
4.Press the PLAY key (˙ or ¥) of the deck you want to start first.

You can start continuous playback from either TAPE 1 or TAPE 2.

Playback cycles through four tape sides as fol- lows, and will continue until you stop the opera- tion.

TAPE 1

Side“A” ∑ Side “B”

™≈

TAPE 2

Side “B” ß Side “A”

Blank scan

To disable this function, press the BLANK SCAN key again. The indicator turns off.

Very quiet passages in music are likely to be identified as blanks. If you are worried about this, switch off Blank Scan.

The Blank Scan function detects 10 seconds or more of blank and skips over it.

To activate this function, press the BLANK SCAN key followed by the desired play key (˙ or ¥).

The BLANK SCAN indicator lights when this function is activated.

14 TASCAM 202MKIV