6Model 220Safety
Anequipot ential grounding lug is provided with this
unit. Some countries require the grounding lug be
properly attached to the rear of the frame by the
authorized installer. The installation location is marked
by the equipotential bonding symbol (5021 of IEC
60417-1) on both the removable panel and the unit’s
frame.
DO NOT use a water jet to clean or r inse the
unit. Failure to follow these instructions may result in
serious electrical shock.
SDO NOT allow untrained personnel to operate
this unit.
SDO NOT operate the unit unless all service
panels and access doors are restrained with
screws.
SDO NOT remove any internal operating parts
(including, but not limited to, freezer door,
beater, or scraper blades), unless all control
switches are in the OFF position.
Failuret o follow these instructions may result in severe
personal injury, especially to fingers or hands, from
hazardous moving parts.
This unit has many sharp edges that can
cause severe injuries.
SDO NOT put objects or fingers in the door
spout. This may contaminate the product and
cause severe personal injury from blade
contact.
SUSE EXTREME CAUTION when removing
the beater assembly. The scraper blades are
very sharp.
This unit must be placed on a level surface.
Extreme care should be taken when moving the unit for
any reason. Two or more persons are required to
safely move this unit. Failure to com ply may result in
personal injury or damage to the unit.
Access to the service ar ea of the unit must be
restricted to persons having knowledge and practical
experience with the unit, in particular as far as s afety
and hygiene are concerned.
Cleaning and sanitizing schedules are
governed by your state or local regulatory agencies
and must be followed accordingly. Please refer to t he
cleaning section of this Operator Manual for the proper
procedure to clean this unit.
This unit is designed to maintain pr oduct
temperature under 41_F(5_C). Any product being
added to this unit must be below 41_F(5_C). Failure
to follow this instruction may result in healt h hazards
and poor freezer performance.
DO NOT obstruct air intake and discharge openings:
3”(76 mm ) minimum air space on front , rear and sides,
and 7- 1/2” (191 mm) on the bottom. The def lector
should bei nstalled to prevent recirculation of warm air.
Failure to follow this instruct ion may cause poor
freezer performance and damage to the machine.
ForIndoor Use Only: This unit is designed to operate
indoors, under normal ambient temperatures of
70_-75_F(21_-24_C). The unit has successfully
performed in high ambient temperatures of up to
104_F(40_C)at reduced c apacities.
DO NOT run the unit without product. Failure to follow
this instruction can result in damage to the unit.
NOISE LEVEL: Airborne noise emission does not
exceed 78 dB(A) when measured at a distance of 1.0
meter from the surface of the unit and at a height of 1.6
meters from thefloor.