22 Model 220Important: OperatorChecklist
051101
Section 7 Important: Operator Checklist

During Cleaning and Sanitizing

Cleaning and sanitizing schedules are governed by
your State or local regulatory agencies and must be
followed accordingly. The following check points
should be stressed during the cleaning and sanitizing
operations.
We recommend that after t he necessary
batches have been prepared for the d ay, the
machine be cleaned and saniti zed.
ALWAYSFOLLOW LOCAL HEALTH CODES.

Troubleshooting Bacterial Count

j1. Thoroughly clean and sanitize the machine
regularly, including complete disassembly and
brush cleaning.
j2. Useall brushes supplied f or thorough cleaning.
The brushes are specially designed to reach all
mix passageways.
j3. Usethe white bristle br usht o cleant he mixinlet
hole which extends from the mix hopper down
to the rear of the freezing cylinder.
j4. Use the black bristle brush to thoroughly clean
the rear shell bearing located at the rear of the
freezing cylinder. Be sure there is a generous
amount of cleaning solution on the brush.
j5. Properly prepare the cleaning/sanitizing
solution. Read and follow the label directions
carefully. Toostrong of a s olution may damage
the parts and too weak of a solution will not do
an adequate job of cleaning and sanitizing.
j6. The temperature of the liquid mix should be
below 40_F. (4 .4_C.).
j7. The temperature of finished product to be
placed in a hardening cabinet should be
between 23_and 25_F(-5.0_to - 3.9_C).

Regular Maintenance Checks

j1. Replace scraper blades that are nicked or
damaged. Before installing the beater, be
certain that the scraper blades are properly
attached.
j2. Check the rear shell bearing for signs of wear
(excessive mix leakage in rear drip pan) and be
certain it is properly cleaned.
j3. Using a screwdriver and cloth t owel, keep the
rear shell bearing and the female hex drive
socket clean and free of lubricant and mix
deposits.
j4. Dispose of o- rings and seals if they are worn,
torn, or fit too loosely, and replace with new
ones.
j5. Follow all lubricating proc eduresas outlined in
“Assembly”.
j6. If your machine is air cooled, check the
condenser for accumulation of dirt and lint. Dirty
condensers will reduce the efficiency and
capacity of the machine. Condensers should be
cleaned monthly with a soft brush.
Note: For machines equipped with an air filter,
it will be necessary to vacuum clean the filters
on a monthly schedule.
Never use screwdrivers or other metal
probes to clean between the fins.
j7. Onwater cooled units, checkthe water lines for
kinks or leaks. Kinks can occur when the
machine is moved back and forth for cleaning or
maintenance purposes. Deteriorated or
cracked water lines should be replaced only by
an authorized Taylor technician.