14 Model 220Operating Procedures
Turn the bearing holder so the holes are aligned with
theholes in the valve body. Secure with the keeper pin.
Figure 15
Step 4
Installthe freezerdoor. Align the hole in t he cross bar
with the hole in either hinge, and insert the hinge pin.
The cross bar can be assembled for either right orleft
opening. Holding the freezer door firmly, position t he
door onto the cross bar. Align the cross bar with the
opposite hinge and insert the remaining hinge pin.
Figure 16
Make sure the freezer door fits securely over the
freezing cylinder. With the door seat ed over the front
of the freezing cylinder, install the cros s bar screw
assembly in the center of the freezer door through the
cross bar. Tighten securely.
Figure 17
Step 5
Align the holes in the cover c ap assembly with the
holes on the freezer door. Secure with the keeper pin.
Figure 18
Step 6
Slide the rear drip tray into the hole in the left side
panel.
Figure 19