Taylor 028763- M

16 Model 220Operating Procedures

140717

Figure 25

Step 5

Place the control switch in the “EJECT” position. This

will cause the sanitizing solution in the freezing

cylinder to be agitated. Allow to agitate f or five

minutes.

Figure 26

Step 6

Place the control switch in the “OFF” position.

With an empty pail beneath the ejection port, turn the

draw rod handle and pull forward, opening the ejection

port. Draw off all the sanitizing solution. W hen the

sanitizer stops flowing from the ejection port , push the

draw rod back into the valve body and lock intoplace.

Figure 27

Step 7

Assemble the hopper gasket around the top edge of

the mix hopper.

Figure 28

Contents

Main Page Table of Contents Table of Contents - Page 2 Section 1 To the Installer Installer Safety S Site Preparation Air Cooled Units Water Connections Electrical Connections S Beater Rotation Refrigerant Section 2 To the Operator Compressor Warranty Disclaimer Section 3 Safety S 7 Model 220 Operator Parts Identificati on Section 4 Operator Parts Identification 8Model 220Operator Parts Identificati on Beater Door Assembly Accessories Section 5 Important: To the Operator Symbol Definitions Control Switch Dial Light Temperature Control Section 6 Operating Procedures Assembly Page Page Page Sanitizing Page Priming Page Overrun Drawing Product Closing Procedures Rinsing Cleaning/Sanitizing Disassembly Brush Cleaning Section 7 Important: Operator Checklist During Cleaning and Sanitizing Troubleshooting Bacterial Count Regular Maintenance Checks Winter Storage Section 8 Troubleshooting Guide PROBLEM PROBABLE CAUSE REMEDY PAG E REF. Section 9 Parts Replacement Schedule Section 10 Limited Warranty on Equipment TaylorCompany Section 11 Limited Warranty on Parts Page TaylorCompany BLACK BLACK WHITE W/BLUE H P SWITCH (SEE FIG. 1) (SEE FIG. 1) GRN/ FIG. 1 EQUIPOTENTIAL GROUND YEL GRN/ YEL GRN/ YEL 030385-33 030385-62