Disconnected Signals
If the receiver unit does not receive a transmission from a remote chan- nel for 1 hour,the display will show dashes.To correct this problem:
1.Check that the remote is properly positioned, within the appro- priate transmission range. Transmissions are vastly affected by building materials and where the receiver and remote units are positioned. Try various set ups for the best results. Shorten the distance between receiver and remote units when necessary.
2.Check to make sure the transmission path is clear of obstacles and interference.
3.If new batteries are faulty on the initial installation, install fresh batteries. If you did not notice the Low Battery icon warning and the product performed correctly after initial set up, the batteries have lost their charge. Replace batteries (see the Power Sources
4.Press the “Tx” button in the battery20 compartment of the remote to send a transmission signal to the base unit.
5.Press and hold the“Channel” button on the back of the base unit. This will clear the channel setting and the base unit will begin searching for remote sensor transmissions. Press the “Tx” button in the battery compartment of the remote to send a transmis- sion signal to the base unit.
6.Please note that below 32ºF / 0ºC the LCD readout on the re- mote unit may begin to fail display.When this happens the remote will still transmit correct temperature readings to the receiver unit but will not appear on the remote LCD.When the tempera-
ture rises above 32ºF / 0ºC the display will begin to function nor- mally again.section of this manual.)
