How to Set up Your WeatherGuide |
| System |
Base Unit | ™ |
|
|
| |
Your WeatherGuide™ bas unit may b | powered by either an AC | |
adaptor (included) r 2 AAA batteries (not includ d). | ||
Adaptor ower – ins r the connector end of the adaptor into | ||
the jack on the side of the base nit. Plug the other end into the | ||
pr per electrical outlet. |
|
|
Battery Power – Remove the battery compartment cover on | ||
the back of the nit. Install 2 AAA batterie . Replace the battery | ||
compar ment cover. |
|
|
Important:Power the base unit befor | installing batteries in the re- | |
m te s nsor,or the units’ ransmissions ma not properlyconnect. | ||
Remote S nsor
Unscrew th 4 screws securing the remote sensor’s battery compart- ment c ver located on the b ck of the unit. Install 2 AAA batteries. (Tip: Lithium batteries are r commende in extremely cold or hot lo- cations.)
First, power up the base unit, using either the AC adaptor or 2 AAA batteries. Next, install 2 AAA batteries into the remote sensor. Place the base unit as close as possible to the remote unit.
There 3is a Channel switch in the remote sensor battery compartment. Move the
Move channel switch
to Channel 1
Press the Tx button to send transmission signal to base unit
switch to Channel 1.
Press the “TX” button located inside the remote sensor battery compartment.This will send a transmission signal to the base unit. The red LED Indicator light will flash when a signal is transmitted.
